The filter didn't turn on when the settings were applied.

New tablet configurations: Wacom CTH-470, CTH-670, PTH-451.

This preset aren't good for high hovering. Straight: Latency 20-40ms, Strength 20, Multiplier 1, OffsetX 0.7, OffsetY 0.6. Decrease Strength to 1-2 to get more smoothing. Increase Strength to 4-10 to get more sharp. Smooth: Latency ~10 ms, Strength 3, Multiplier 100, OffsetX 1.5, OffsetY 1.Ĭhange OffsetX between 0-2 to switch between stickyness and smooth. Simple: Latency 5-50 ms, Strength 2-3, Multiplier 1, OffsetX 0, OffsetY 1. OffsetY 0.5 will make smoothing roughly twice weaker (and latency will be roughly twice less), 0.3 roughly triple weaker, etc. OffsetY 10 will make smoothing x10 (and latency). Also it defines minimal amount of smoothing. If value is near 1 then it's usual smoothing. Look at the plot, if strength of smoothing is near 0 then it provides almost raw data with lowest delay. Useful values are from roughly -1 up to 10. Higher values make smoothing weaker, lower values stornger and activate stronger smoothing earlier (in terms of cursor speed). Negative values moves the plot to the left. Default value is 1, means nothing changed. Multiplier: zoomIns and zoomOuts the plot. Higher values make smoothing more sharper, lower are smoother. Strength: is strength, useful values are from 1 up to 10. Strength, Multiplier, OffsetX and OffsetY is values which you can change in driver. And y(x) is value on which smoothing will be increased. Y(x) = (x + OffsetX)^(Strength*-1)*Multiplier+OffsetY Latency and Rate values do affect on antichatter settings. Video - same but with prediction disabled: Straight - Pretty good realtime accurateĪntichatter feature is meant to prevent cursor chattering/rattling/shaking/trembling when it's almost doesn't moves and/or too high to prevent tablet noise.Īntichatter in it's primary form is useful for tablets which doesn't have any smoothing (including hardware smoothing).Īntichatter requires smoothing filter enabled for work. PRESETS Smooth 2 + prediction = accurate with small overshot My version based on 0.1.5 version of driver. If you have not installed the driver then:įollow instructions here: and after return to step 1. If you have already Driver installed just: close it, and unzip new version with replacing files.Intended for Wacom tablets but will work with other tablets but not expect everything work correct. This is a my modified version of hawku's tablet driver.

Wacom tablet driver osu